The Framing Equipment Specialists

Mitre Guillotines

       Click on picture to see enlargement

Mitre Guillotine

This Mitre Guillotine guillotine has been developed to give the gallery picture framer and volume framer both speed and quality cutting.

Mitre guillotines have 2 blades usually set at 90 degrees. The foot pedal operation brings the blades down to chop thought the moulding producing a 2 opposite mitres. A single chop however will crush and damage the moulding. A re-positionable cutting head allows you to advance the blades and chop through the moulding  as many times as is needed to provide the best quality cut. 

 Cutting Capacity

 Width  100mm  Height  160mm

 Key Benefits

• Complete with sliding stops and a metric measuring system for quick and easy resetting between frames.
• Perspex finger guards and perplex guards fitting over the blades for your safety. 
• Rebate support to prevent damage been caused to the lip of the moulding. 
• The blades can be reset to cut mitres between 45 and 90 degrees for multi angle frames.
• Complete with a spare set of blades and a 10 year warranty
• Spare set of blades supplied

 Pricing

    Click on picture to see enlargement

Pneumatic Mitre Guillotine

The same guillotine as above but with pneumatic cylinder instead of a foot pedal.

Key Benefits

• Great for those very hard mouldings

• Even better for framers whose knees are getting a little tired

• Speeds production for  framers needing higher output.

• No need for a large compressor

Pricing

Digital  Gauge

Designed for mitre guillotines. Another  first from TABMASTER.

Key Benefits

• No more wasted moulding due to human error.

• Accurate direct digital read out .

• Save time, save money.

 Back to top